Corrosion, deterioration, and section loss at issue in 2022 Pittsburgh bridge collapse
WASHINGTON (May 18, 2023) —The National Transportation Safety Board recommended Thursday that federal and state authorities review inspection reports and identify incomplete follow-up actions that need to be resolved for bridges made of uncoated weathering steel, citing the ongoing investigation of a 2022 bridge collapse in Pittsburgh.
On Jan. 28, 2022, the 447-foot-long Fern Hollow bridge experienced a structural failure and fell approximately 100 feet into the park below. Six vehicles were on or near the bridge when it collapsed, injuring four.
NTSB investigators found corrosion, deterioration, and section loss on all four of the bridge’s legs due to the continual accumulation of water and debris. Some of the section loss was so severe, it resulted in holes. Uncoated weathering steel requires periods of dryness to form a protective oxide coating, or patina, that resists corrosion over time. Debris, dirt, and leaves were blocking the drainage systems on the Fern Hollow Bridge, allowing water to drain onto areas not intended for water flow and preventing the protective patina from forming.
NTSB investigators found that prior inspections of the Fern Hollow bridge performed on behalf of the Pennsylvania Department of Transportation identified problems with drainage, but maintenance was not regularly performed to resolve the issue. NTSB investigators found other Pennsylvania bridges with similar issues with drainage, debris accumulation and corrosion.
The NTSB is now asking the Federal Highway Administration to develop a process for bridge owners nationwide to perform necessary follow-up actions on bridges with uncoated weathering steel components.
While the Fern Hollow bridge investigation is not yet complete, the NTSB is making this early recommendation due to the immediate implications for bridge safety nationwide. The final report with a probable cause, other findings and recommendations will be issued in the coming months.
The NTSB is also releasing new documents including a NTSB Materials Laboratory report with photos and 3-D laser scans of the deterioration on the bottoms of all four bridge legs. The interim report and a summary of the investigative actions taken so far are available on the NTSB’s website.
Three-dimensional laser scan image showing remaining section on bottom of northwest leg (pictured rotated on its side) of the Fern Hollow Bridge post collapse. More information is available in the related NTSB Materials Laboratory report.
To report an incident/accident or if you are a public safety agency, please call 1-844-373-9922 or 202-314-6290 to speak to a Watch Officer at the NTSB Response Operations Center (ROC) in Washington, DC (24/7).
